晶片組的選項那邊, 先不要勾選任何省電選項, 電壓用預設先試看看~ 我自己的Opteron只能用單步跳頻(倍頻), 多步的話也是會當. FYR~

我都是用預設電壓值，我試過如果分別用 5 倍頻及 10 倍頻來使用，系統都相當穩定，但如果讓它自己跳頻就會當機。

很明顯，這個問題應該是跳頻出了問題，我是認為可能是主機板對 CPU 支援的問題。

之前也有試過，是比 RM Clock 好一點，但也是會當。

rmclock之類的
和主機板或晶片組有相容性問題
之前用k8n neo2完全正常
k8t就是狂當
所有設定全照官方預設還是狂當
只能改用crystalcpuid才正常

現在用phenom II這些軟體都不支援真可惜

啟用cnq時使用AOD好像會造成電源選項的效果有變化
我現在xp的最小電源管理已經變成維持全速了
不知怎麼改回來

別的地方看到的

Enabling Cool’n’Quiet on Windows 7 is the same as it is on Windows Vista…

“DO:”
· C’n’Q must be “enabled” in the motherboard’s BIOS (Note that most BIOS settings disable it by default)
* For optimal power savings, be sure to also enable C1E and DRAM Power Down in the BIOS
· The power management scheme/setting must be "balanced" or "power-saver" in the control panel (note that this is the default setting)
· The motherboard’s BIOS must recognize the CPU that is installed (BIOS status screen will properly display CPU model number upon boot-up)
* You can verify C’n’Q is working with a utility tool such as “CPU-Z” or “AMD Power Monitor.”

“DO NOT:”
· Do NOT Select “Performance” as Windows 7’s power management scheme/setting as it will disable C’n’Q functionality
· Do NOT manually set the CPU frequency or multiplier in the BIOS. Doing so will lock the processor speed and disable C’n’Q functionality
· Having an old BIOS that does not properly recognize the CPU may disable C’n’Q functionality (flash your BIOS to latest version)
· There is NO need to install a separate AMD CPU driver… Windows 7 has the AMD CPU driver built-in already

挖墳文......


新的 AM2+ 以上CPU 請改用 K10STAT