謝謝熱心的狂大大
我的Sandra是2003.3.9.44版的
在這裏下載的：
http://www8.pconline.com.cn/downloa...phtml?id=104774
在mainboard information裏,關於AGP
AGP Bus(es)
Version : 2.00
Current Data Transfer Rate : 1x
Maximum Data Transfer Rate : 4x
Side Band Enabled : No
Side Band Support : Yes
Fast-Writes Enabled : No
Fast-Writes Support : Yes
那個version2.00是代表AGP 2x嗎?
或者是看下兩行,說目前1x,最多可到4x,表示是AGP 4X??
還有電壓的部份,Sandra顯示：
Voltage Sensor(s)
CPU Voltage : 1.73V
Aux Voltage : 1.57V
+3.3V Voltage : 2.77V
+5V Voltage : 4.84V
+12V Voltage : 11.98V
-12V Voltage : -12.03V
-5V Voltage : -5.05V
Standby Voltage : 4.87V
Battery Voltage : 3.07V
3.3V那個只有2.77V,算起來差了16%,會不會差太多了?
我用MBM5看,會在2.75到2.77V間跳動
問題比較有可能是出在主機版還power?
我的power是Aopen FSP530-60GN
http://www.aopen.com.tw/products/power/fsp530-60gn.htm
應該不會不足瓦吧??
還有mainboard information最後有個Performance Tips
點進去關於AGP那一項後,出現：
Tip T2525 - Current AGP data rate not optimal, i.e. less than chipset’s maximum AGP data rate. E.g. current AGP data rate is 1x while the chipset and the AGP card both support 2x. You should get better performance with a higher data rate but this depends on the application.
Fix: First, use the PCI & AGP Information module to confirm that the AGP card also supports the maximum chipset data rate. If it does not, don’t worry about it. For non-Intel chipsets, make sure you install the latest version of their AGP mini-drivers. You should update the video card drivers as well. Some non-Intel chipsets can only work in 1x mode with some video cards.
意思是不是說我卡可以跑到AGP 2x,
可是目前只跑1x
因為不是intel的晶片組,
所以如果沒裝nforce2.03的話,
我的顯示卡就只能跑1x??
那怎麼跟前面說最多可跑到4x有矛盾??
不好意思,一直麻煩狂大大
謝謝你的熱心