ISO 轉 BD-RE DL (50G->50G) 超過容量, 怎辦
 

AnyDVD 6630 轉成的 ISO
可用 PowerDVD 播放
但用 ImgBurn 2510 燒錄至 SONY BD-RE DL (50G) 出現

Image Size 24,111,104 Sectors(47,092 MB)
Disc Size 23,652,352 Sectors(46,196 MB)
Would you like to continue anywhy?

試過 continue, 結果是 Fail,
改用 CLoneDVD2 也是容量不足的訊息.

請問單兵如何處置?

用 BD-R DL 可以

有沒有把預藏糾錯空間給釋放出來?? 如果DL ISO to DL的話用Imgburn.

用DVD Fab把IS0檔內****和不要的語言字冪去悼看看,我都是以BD一R燒錄從未發生問題.OR In ImgBurn 設定如下: 1.switch the file system option"UDF" on the option Tab
2.Enable the "Allow Files Exceeding Size Limit" option on the advance
-Restriction-ISO9660 Tab"

謝謝大家!!
測試成功了!! 總結一下
拿到新的 BD-RE 要記得先拿 ImgBurn 低階格式化一下才能使用到最大的容量.
ImgBurn 預設就是 Perfer Format without Spare Areas, 所以直接 Erase Full 即可 .
完成後記得退片, 再重新讀取即可.


網路上看到這篇, 應該算是解答了.
做完之後, 還要退片再重讀一次.

Once you have the media, you want to do a low-level format. To do this, run ImgBurn, and open up
Tools > Settings > Write. Check the box next to "Prefer Format Without Spare Areas." This sets
ImgBurn to format without a SSA if possible. Then do a full erase. (It calls it a full erase, but
it's actually sending the FORMAT UNIT command to the drive.) After you do this, eject and re-insert
the disc so that Vista recognizes the extra space.

= ImgBurn Disc Info (factory formatted) =

Preferred Format Capacity:
Sectors: 2,236,704
Size: 4,580,769,792 bytes
Time: 497:04:54 (MM:SS:FF)

Maximum Format Capacity:
Sectors: 2,295,072
Size: 4,700,307,456 bytes
Time: 510:02:72 (MM:SS:FF)