這下可怪了
有前輩可以猜看看問題出在那嗎
AOpen的人拿了一樣的板子測
竟然在S3後不會跳回cpu default clock
轉貼自AOpen Global網站：

From:Niño(2007/12/20 02:09:27)
Dear Unicorn,

..........

However, for curiosity, I started conducting series of test in here in accordance to your system configuration. Please check the results below during test and verification.

System Configuration:

Motherboard: AX4B-533 Tube
BIOS: R1.07
CPU: Intel P4 2.4GHz ,512KB, 533MHz FSB, 1.525v core voltage
Memory: X2, Apacer DDR400 PC3200 256MB
AGP: ATI Radeon 9700 Pro
IDE1: Seagate 40GB
IDE2: AOpen DVDRW drive
PSU: ATX 300GT

Considering that I configured properly my system like installing OS and its drivers. Then, initially set S3 thru Power Management in Bios then entering Frequency/Voltage control to check the initial setting 133MHz FSB then hit escape to enter main menu then save and exit the program. In Windows XP SP2 at control panel then Power Option under system standby change setting there from which I preferred. Tested the system without tampered the keyboard and mouse and it automatically goes into standby. Also, tried to standby manually by clicking Start- Shutdown – Standby without any issues on this matter as per result for almost 10 times each it won’t go back to 133MHz. Now, we ask from you, did you configure your system properly? We suggest to use the Bios R1.07 then observe the results.

............

Best Regards,
Niño
AOPEN Technical Support Division
December 20, 2007


Sorry I forgot to say that I tried to change the Bus Frequency of Processor setting as follows: 133MHZ, 135MHZ, 138MHz and 140 and it won’t go back to 133MHz.

Thank you!

該不會是板子被操到內傷了吧...

會不會是板子的版本不同
不然就是樓主本身系統超頻後的穩定度不及AOPEN的

請愛用Suspend to Disk .

STD比開機還慢啊
超頻會造成clock generator讀不到復電後的FSB設定嗎？
我的板子在待命前都穩當當啊

不知道 AOPEN 有沒有可現場檢測的地方, 樓主需要做的是第三方單位驗證.
搞不好從頭到尾只是樓主搞烏龍就尷尬了.

小弟不信邪立刻找人買了一片全新的
果不其然，一樣！！！
調100MHz待命後一樣回到133MHz
所以確定超頻不是死因
也不是烏龍吧

有可能是周邊搭配的問題
例如ram,power,U的體質
還有BIOS參數的設定鬆緊

超頻跟CLOCK比較有關係.
要看版主主機板上是哪一枚CLOCK.
目前某些主機板超頻1333的時候.是根本不給S3的狀態.
建議版主不要用S3吧...

反正樓主就是卯起來硬幹了,不如:
A. 用焊的把CLOCK_GEN IC 的 CLOCK 鎖死在133 FSB (跳線).
B. 或把CPU的FSB接腳 拉線 鎖在預設133 FSB .