Basic Member
加入日期: Sep 2001
文章: 19
|
Mobile K8 Sempron 2800+ 與 ALPHA U81C-60C
今天終於弄好的主機^^"
今天的主角們: CPU:AMD Mobile K8 Sempron 2800+ (25W低電壓版) MB:ASUS K8S-MX (有PCI-E X1的怪板子) RAM:創見 DDR400 1G (UCCC 525週期) 散熱器:ALPHA U81C-60C (無風扇K8散熱器) 整個系統只有一顆系統風扇跟S12的風扇 配合CrystalCPUID 在待機時跑800Mhz,全速跑1600Mhz 待機10分鐘,CPU溫度約44度,主機板溫度約40度 http://sweb.nuu.edu.tw/~a9322320/sempron-0.jpg 跑MemTest半小時,CPU溫度約57度,主機板溫度約37度 http://sweb.nuu.edu.tw/~a9322320/sempron-1.jpg 待機10分鐘後,CPU溫度約49度,主機板溫度約40度 http://sweb.nuu.edu.tw/~a9322320/sempron-2.jpg 待機20分鐘後,CPU溫度約46度,主機板溫度約40度 http://sweb.nuu.edu.tw/~a9322320/sempron-3.jpg 怎麼跑全速的時候主機板溫度還比較低啊 難道是因為ALPHA的熱對流影響:P 整台主機全速跑一個晚上也沒有發生熱當 溫度穩定在57度上下 感謝收看 |
|||||||
2005-08-31, 12:31 PM
#1
|
Amateur Member
加入日期: May 2004
文章: 49
|
引用:
elementaler兄的這個主機相信靜音是第一需求囉 看起來真的挺有創意的~ 而且南橋和POWER IC還特別加散熱片改裝 好奇問一下 (1) 關於Mobile sp2800+(25w)有支援CnQ或是倍頻調整嗎? 如何做到800 <-> 1600間的切換 (2) K8S-MX有無支援ASUS Q-fan的功能 該系統風扇的轉速是固定速度 或是依溫度做轉速調整 謝謝! 此文章於 2005-09-02 11:21 AM 被 ckyaong 編輯. |
|||
2005-09-02, 11:20 AM
#2
|
Basic Member
加入日期: Sep 2001
文章: 19
|
有支持CNQ唷,不過我是用CrystalCPUID來設定調整倍頻的。
很可惜的是這張主機版沒有Q-Fan的功能, 有空在試看看溫控風扇好了^^" |
2005-09-02, 12:03 PM
#3
|
Power Member
加入日期: Jul 2004 您的住址: 台北市
文章: 643
|
One story about my xp-m 1600+[25w]with CrystalCPUID, I installed an ADDA 8cm 1600 rpm fan over the heatsink, after mess around inside, then I start the computer, about 5 min later, I looked at speedfan temperature, 53 C, it had never been so high, so I shut it off, opened the case, the fan was stopped by the wire, if it was Thunderbird or other XP, it would be good-bye.
Silent setup PSU SEASONICS SUPER TORNADO 300W [測試分享]K8 拿掉風扇 跑Prime95 http://forum.pcdvd.com.tw/showthrea...32&page=2&pp=40 “With my current setup there is no audible benefit in running the CPU (nearly) fanless, so I let the CPU fan spin at 5V all the time.” http://www.silentpcreview.com/article231-page3.html 此文章於 2005-09-02 01:38 PM 被 MDD 編輯. |
2005-09-02, 01:28 PM
#4
|